Drying a structure correctly isn't about running a few fans and hoping — it's a calculated process based on temperature, humidity, and airflow readings.
We calculate air mover and dehumidifier placement using psychrometric formulas, not a flat per-room equipment count.
A calculated drying plan means faster results with the right amount of equipment, not excess.
Low Grain Refrigerant dehumidifiers pull significantly more moisture from the air than consumer-grade units.
Thermal imaging cameras reveal moisture patterns behind walls and under flooring that aren't visible to the eye.
You receive documented daily readings showing the structure actually getting drier.
Below is the calculated, documented process our Burke, SD teams follow.
The assessment sets the baseline every later reading gets measured against.
Thermal imaging often reveals moisture has traveled further than the visible damage suggested.
Dehumidifier capacity is matched to the calculated moisture load for that specific space.
Documented logs track the numbers from day one through final verification.
Hardwood floors and built-in cabinetry require slower, more controlled drying to avoid warping.
Final verification compares closing readings against the material-specific dry standard, not a general guess.
We ask enough to bring the right instruments on the first visit.
Our nearest Burke, SD crew brings diagnostic equipment loaded from the start.
You'll see the calculated plan and cost before drying equipment goes down.
The job closes only once documented readings confirm the structure is fully dry.
"The thermal imaging found moisture behind a wall that looked completely fine from the outside. Would have missed it otherwise." — Julian R.
"They came back every single day to take readings and showed me the numbers improving. Felt like real science, not guesswork." — Monique T.
"Our hardwood floor didn't warp because they slowed the drying process down specifically for it." — Grant P.
Visual appearance doesn't confirm dryness — instrument readings are needed to catch what's not visible.
It's the technical foundation behind Structural Drying And Dehumidification rather than a marketing term.
Typical drying time is 3-5 days for standard materials, longer for sensitive ones like hardwood.
We provide daily documented logs showing moisture readings, not just a verbal update.
Specialty drying protocols protect hardwood and cabinetry from the damage a standard drying speed could cause.
A stall in the daily logs triggers a plan review rather than simply leaving equipment running unchanged.
If your property is in or near Burke, a crew can typically respond the same day.
Speak directly with our structural drying team.
Call +1-844-833-1325